Bleeding a radiator is one of the few heating jobs that is genuinely yours to do. It needs no gas work, no tools beyond a radiator key, and about ten minutes. It also has limits, and knowing them saves a lot of frustration.

Before you start

Turn the heating off and let the radiators cool down. Two reasons: the water inside a hot radiator can scald, and with the pump stopped you are letting air out rather than drawing more in.

You will need a radiator key from any hardware shop (some newer valves take a flat screwdriver instead), an old cloth, and something to catch drips.

Doing it

  • Find the bleed valve. It is the small square fitting at one of the top corners of the radiator.
  • Hold the cloth underneath it and turn the key slowly anticlockwise, about a quarter turn. You do not need to open it any further than that.
  • Listen. A hiss is air escaping. Leave it until the hiss stops and water starts to come out.
  • Close it as soon as you get water. Firmly, but do not force it.

Do the same on any other radiator that was cold at the top, then put the heating back on and check that they warm up evenly.

Then look at the boiler

This is the step people miss. On a sealed system, which most homes with a combi boiler have, letting air out also lowers the pressure. Check the gauge on the boiler afterwards. If it has dropped below where your manual says it should sit, it will need topping up, and if it is too low the boiler may refuse to fire at all. Your boiler's manual explains how to repressurise it; if you are not sure, ask rather than guess.

Older open-vented systems, with a small tank in the attic, top themselves up and do not have this problem.

What bleeding fixes

Air. If a radiator is cold at the top and warm at the bottom, trapped air is the usual cause, and bleeding sorts it out. We covered how to read those patterns in an earlier post.

What it does not fix

  • Cold at the bottom, warm at the top. That usually points to sludge settled in the radiator. No amount of bleeding touches it.
  • A radiator that stays cold all over. Often a stuck valve, or a system that needs balancing.
  • Air that keeps coming back. If you are bleeding the same radiator every few weeks, air is getting in somewhere, and that is the real problem.
  • A bleed valve that will not turn, or will not seal. Do not force it. A snapped or leaking valve is a plumbing job.

If bleeding worked, grand. If it did not, or the problem keeps coming back, tell us what the radiators are doing and we will tell you honestly whether it needs a visit.